#Snes9x 1.53 full
#Snes9x 1.53 software

Also make sure that Fullscreen is set to true and EmulateFullscreen is set to false (same file, a few sections above), otherwise it will try using desktop control settings by default. It's setup to emulate how an SNES controller would feel so A/B and X/Y are flipped. Load up nf and under the section copy and paste this (its from my file so it SHOULD* work)

#Snes9x 1.53 software

Nvidia software shouldn't be an issue since I have my overlay whatnot still enabled.Sure, I have a few free minutes, if you're having problems mapping the controller, sometimes its easier to add the X-input junk right into the config file. May want to try closing other programs until you find what is causing the issue. If none of this works, there may be something very specific to your computer running that may be conflicting. You can also set the emulator to accept inputs when it isn't the active window.

#Snes9x 1.53 full

So, a normal press works normally, but holding select for a few seconds is the same as pressing Escape on keyboard and holding Start is bound to Alt + Enter (toggles full screen in this case)Īny issues I have with the steam overlay or nvidia overlay are usually fixed by long pressing Start twice to bring it out of full screen and back into full screen. Especially with emulators, I usually add a long press function to my start and select buttons. and change it to be all normal controller inputs, then even if it finds it to be a desktop app, you should still be able to map input in the emulator and will only be able to use it as a mouse while holding the home button as I said earlier.Įdit: It may also be that the emulator loses focus, this making the computer think it should use the desktop config. You'll usually find that as long as you hold the home button on the controller, you'll be able to use it as a mouse, once you let go, it should function as a controller.Ībsolute worst case, go to steam settings > Base Configurations > Desktop configuration. Inside of steam, go to settings > Base Configurations > Steam Button Chord configuration. It SHOULDN'T be thinking of the emulator as a mouse as long as you make sure to set controller bindings within steam before launching the emulator. To get around that issue, on the steam end, I changed the controller's d-pad into an analog stick. Best information I was able to get on why that doesn't work over the steam link is that the emulator doesn't support xinput or dinput, whichever the steamlink outputs. Well, with the minor caveat of diagonal inputs not working.

I use a DS4, Steam Controller, and wired 360 controller without issue. I use the same setup almost daily with the same emulator. The setup previously mentioned should work fine. And on a final note, if you're using custom controller settings, make sure its set to a standard xinput controller.

I'd also recommend setting the file to 'read only' because for some reason it likes to unset fullscreen to false, at least for me.

Sure, I have a few free minutes, if you're having problems mapping the controller, sometimes its easier to add the X-input junk right into the config file.